ENGINE MECHANICAL (J05E)
10–5
2.
MOUNTING THE HEAD COVER
(1)
Remove the dirt (including the liquid gasket) or oil on the joint sur-
face of the head cover and cylinder head.
(2)
Mount the new head cover gasket to the head cover groove.
(3)
Set the head cover to the cylinder head mounting position and
mount it with 13 bolts through the silent block.
Tightening Torque:
28.5 N·m {291 kgf·cm, 21 lbf·ft}
! CAUTION
•
The head cover has a floating mount structure. Do not
tighten the bolts too tight.
•
To avoid interference or contact with harnesses, harness
brackets, and other cylinder head inner parts, carefully
mount the head cover without applying excessive force.
•
Wait at least 15 minutes after assembly before start of driv-
ing.
(4)
Remove the swollen liquid gasket completely.
NOTICE
Rubber spacers are attached to the silent block.
3.
CONNECTING THE HARNESS
(1)
Mount the harness to the cylinder head, then connect the connec-
tor.
4.
MOUNTING THE CLOSED VENTILATOR HOSE
Reference: EMISSION CONTROL (J05E), CLOSED VENTILA-
TOR, REPLACEMENT, MOUNTING THE CLOSED VENTILA-
TOR (Page 8-16)
BOLT
SILENT
BLOCK
HEAD COVER
HEAD COVER
GASKET
SHTS021270900007
BOLT
SILENT
BLOCK
HEAD COVER
HEAD COVER
GASKET
HEAD COVER
LOWER SIDE
CYLINDER
HEAD
SHTS021270900008