Hardy Process Solutions HI 2160RC PLUS, Operation And Installation Manual

Page: 79 / 220

HI 2160RC
PLUS
MANUAL
5-12
• Increase/Decrease the OP output signal by increments of
1%.
Press the Select/0 button. The number to the left of
the decimal point begins flashing.
Press the up arrow
↑
to increase the output signal
percentage (driver RPM) in increments of 01.0%
and down arrow
↓
to decrease the output signal
percentage (driver RPM) in increments of 01.0%.
• Increase/Decrease the OP output signal by increments of
10%. (See Fig. 5-5)
Press the Select/0 button. The number to the left of
the decimal point begins flashing.
Press the up arrow
↑
to increase the output signal
percentage (driver RPM) in increments of 10.0%
and down arrow
↓
to decrease the output signal
percentage (driver RPM) in increments of 10.0%.
S e t R a t e M A N U A L L / M
O P 1 0 . 0 % A c t 0 . 0 0
C u r r e n t W e i g h t i n
O N S c a l e 1 2 3 . 4 5 L B
FIG. 5-5 OUTPUT SIGNAL IN 10% INCREMENTS
Step 13. Set the Operating Percentage for 10% increments.
Step 14. Press the up arrow
↑
a few times and down a few times to see
if the feeder is increasing and decreasing the material feed
rate.
Step 15. To pause the feeder press the Stop button.
Step 16. At the lower left corner of the screen you will see that the sta-
tus is "HLD". (See Fig. 5-6)