Hardy Process Solutions HI 2160RC PLUS, Operation And Installation Manual

Page: 70 / 220

Chapter 5 - Calibration
5-3
Step 3. If the display is reading improperly or shows no change there
is something wrong either with the configuration or installa-
tion.
Step 4. If the display changes in the proper direction move onto the
calibration of the controller.
Weight Calibration
Process
Calibration Setup
Procedures Step 1. Press the "Config" button. The security display appears.
Step 2. If the unit is being calibrated for the first time, use the
numeric keys and enter the default high code value numbers
"1 2 3 4".
Step 3. If a high code value other than the default number has been
entered use that number.
NOTE: You can press the "Enter" button, but it may only permit read only access to all the
calibration parameters you want to change. We highly recommend using the High
Code number.
Step 4. Press the Enter button. The Main Menu appears.
Step 5. Press the down arrow
↓
button until the cursor is next to the
"Calibration" sub-menu.
Step 6. Press the Enter button. The Mass Units sub-menu appears.
Setting the Mass
Units
Step 1. Press the "Select" button to scroll through all the Engineering
(weight and volume) Mass Unit selections which are:
LBS = pounds Default
OZS = ounces
TNS = tons
KGS = kilograms
GLS = gallons
LTR = liters
MLT = milliliters
GRM = grams
Step 2. When you have scrolled to the selection you want, press the
Enter button. The entry accepted is briefly flashed on the dis-
play.`
Step 3. The Mass Units are used in the displays and on reports.
NOTE: The HI 2160RC
PLUS
Rate Controller does not perform conversions between the vari-
ous mass units. To change the mass units, a weight re-calibration of the controller is
required.
Step 4. Press the down arrow
↓
button until the cursor is in front of
the Time Unit sub-menu.