MAN3186 - TITANUS MICRO
•
SENS®
97
4
0.1
Chapter "Simplified project planning"
10
4
Chapter ""Project planning with single
hole monitoring"
Special
10
4
Standard
Max.
Min.
d [m]
Project planning
Intervals of the aspiration
apertures
The permissible min. and max. distance (d) between the aspiration apertures
must be taken into account, depending on the type of project planning.
Image 58:
Intervals of the aspiration apertures
Depending on the type of project planning, the following threshold values
apply for the intervals between the aspiration apertures as well as for the
intervals between the T
‑
piece and the first aspiration aperture of the
following stub:
Table 42:
Permissible intervals between the aspiration apertures
If the maximum interval (d
max.
) is exceeded, this can be rectified by an
additional aspiration aperture on the stub. Please note that a maximum of
two aspiration apertures may be planned on each stub.
Diameter of aspiration apertures
The diameters of the aspiration apertures can be found in the corresponding
chapter, depending on the type of project planning (e.g. standard or special
project planning with acceleration openings).
A
C
D
F
H
I
J
L
B
E
G
K
M
Image 59:
Diameter of aspiration apertures
A
C
D
E
G
H
I
K
B
F
J
L
d
e
vi
ce
d
e
vi
ce
d
B
d
E
Summary of Contents for Ampac TITANUS MICRO-SENS
Page 229: ......
