120
Calibration and Configuration
P/N: SM-ACP215-01-EN(AB)
Haemonetics
®
ACP-215
®
Service Manual
7. Use
MODIFY PROGRAM
to move the cursor and
YES
and
NO
to select
the digit.
8. Press
STOP
three times to exit. The following screen appears:
9. Switch the memory protect switch on the CPU board to the Protect On
mode (up) and the following display appears:
10.Press
STOP
and the device restarts and perform the self test.
RS232 Device (Printer Selection)
Note: In order for the device to send data to the printer, the RS232 device must
be set to “Printer”.
1. Access the Utilities mode of operation by pressing and holding
SHAKER
while switching the power on. Hold
SHAKER
until the UTLITIES menu
appears on the display.
2. Press
MODIFY PROGRAM
to move the arrow to CONFIGURATION and
then press
START
.
3. The message REMOVE MEMORY PROTECTION OR STRIKE STOP
appears.
4. Switch the memory protect switch located toward the bottom of the CPU
board (the left-most card cage board, looking from the rear of the unit) to
the Protect Off mode (down). The CALIBRATION screen appears with
three choices: PROTOCOLS CONFIGURATION, LANGUAGE, and
MACHINE.
5. Press
MODIFY PROGRAM
to move the arrow to MACHINE, then press
START
.
CONFIGURATION
PROTOCOLS CONFIGURATION
—> LANGUAGE
******************************
**
REPLACE MEMORY
**
**
PROTECTION
**
******************************
UTILITIES
CALIBRATION
DIAGNOSTICS
—> CONFIGURATION
MAINTENANCE
