Operation Manual – Process Server Configuration
H3C XE 200/2000 IP PBX
Chapter 5 SIP Server Configuration
5-3
Perform the following configuration in PS view.
Table 5-4
Configure information on the PS
Operation
Command
Configure the identifier of the PS and specify its
interface
ps-config identifier interface
interface-type interface-identifier
Remove the basic configuration of the PS
undo ps-config
V. Enabling/disabling a PS
Enabling/disabling a PS with the
start
or
stop
command is a software reset operation.
The operation will interrupt ongoing calls, disconnecting the PS from the LS and
preventing it from receiving messages from gateways. Then the PS reconnects with the
LS for receiving messages from gateways.
Perform the following configuration in PS view.
Table 5-5
Enable/disable the PS
Operation
Command
Enable the PS
start
Disable the PS
stop
Note:
Disabling the PS will disable the gatekeeper and SIP Server.
VI. Enabling/disabling long-time call interruption function
This command is used to enable/disable long-time call interruption function. Each time
you use the function, a timer is enabled on the server which will break the conversation
when timeout interval expires on the timer.
Perform the following configuration in PS view.
Table 5-6
Enable/disable long-time call interruption
Operation
Command
Enable long-time call interruption
policy call-interrupt-by-long-time enable
Disable long-time call interruption
policy call-interrupt-by-long-time disable
Summary of Contents for XE 200/2000 IP
