H3C XE 200/2000 IP, Operation Manual

Page: 451 / 514

Operation Manual – Call Services
H3C XE 200/2000 IP PBX
Chapter 19 Time Announcement Service
19-1
Chapter 19 Time Announcement Service
19.1 Overview
19.1.1 Introduction to Time Announcement Service
With the time announcement service, a subscriber can dial the access code to the XE
IP PBX to query the current time. The time presented by the XE IP PBX is its current
system time.
Note:
To use the time announcement service, you need to enable the MS on the XE IP PBX
first. Otherwise, a subscriber will hear the busy tone when attempting to use this
service.
19.1.2 Using Time Announcement Service
Before the time announcement service is available for a subscriber, an authorized
administrator must enable it for the subscriber first. Refer to Enabling/Disabling Time
Announcement Service for operation details.
Table 19-1 Use the time announcement service
Step Expected result
The subscriber picks up the phone. The subscriber hears dial tones.
The subscriber dials *90*0#.
If the service is enabled, the subscriber
hears the voice prompt “The current time
is
XXXX ”, provided the corresponding
media resource is configured.
If the service is not enabled, the
subscriber hears the voice prompt
“Sorry, the service is not available”, even
if the media resource is configured.
If no media resource is configured, the
subscriber will hear busy tones.
The subscriber hangs up. —