H3C XE 200/2000 IP, Operation Manual

Page: 292 / 514

Operation Manual – System Management
H3C XE 200/2000 IP PBX
Chapter 4 System Maintenance and Management
4-10
Table 4-12 Configure the source address in log information
Operation Command
Set the source address in log
information
info-center loghost source
{ interface-type interface-number |
interface-name } [ subinterface-type ]
Cancel the current configuration undo info-center loghost source
4.2.3 Configuring Terminal Display
Configuring terminal display is to control on user screens whether to display the
debug/log/trap information from the information center.
Perform the following configuration in user view.
Table 4-13 Configure terminal display
Operation Command
Enable the terminal to display information terminal monitor
Enable the terminal to display log information
terminal logging
Enable the terminal to display trap information terminal trapping
Enable the terminal to display the debugging terminal debugging
Disable the terminal from displaying information undo terminal monitor
Disable the terminal from displaying log information undo terminal logging
Disable the terminal from displaying trap information undo terminal trapping
Disable the terminal from displaying debugging
information undo terminal
debugging
These commands only affect the display on the current terminal where the commands
are executed.
The undo terminal monitor command has the same function as the combination of
undo terminal debugging , undo terminal logging , and undo terminal trapping
commands. When the undo terminal monitor command is enabled,
debugging/log/trap information will not be sent to the current terminal.
When the terminal monitor command is used, you can use the terminal
debugging/undo terminal debugging , terminal logging/undo terminal logging ,
and terminal trapping/undo terminal trapping commands to enable/disable
debugging/log/trap information output.