Operation Manual – Location Server Configuration
H3C XE 200/2000 IP PBX
Chapter 1 Location Server Configuration
1-29
Table 1-46
Configuring the priority of a static route number of an office group
Operation
Command
Configure the priority of a static route
number of an office group
priority priority-level
Restore the default priority
undo priority
II. Specifying whether to enable multiplexing
Use the
multiplex
command to specify the multiplexing mode of an office device
configured on an LS.
Perform the following configuration in LS-OFFICEGROUP-OFFICE view.
Table 1-47
Specify whether to enable multiplexing
Operation
Command
Specify whether to enable multiplexing
multiplex
{
disable
|
enable
}
Restore the default setting
undo multiplex
By default, multiplexing is disabled.
III. Configuring attribute of a static route number of an office group
For the attributes of a static route number, refer to
Configuring attribute of a static route
number of a gateway
.
Perform the following configuration in LS-LS-OFFICEGROUP-PREFIX view.
Table 1-48
Configure attribute of a static route number of an office group
Operation
Command
Configure attribute of a static route
number of an office group
otapc
{
fxs
|
relay
}
Restore the default attribute
undo otapc
By default, the static route number is the user number.
Summary of Contents for XE 200/2000 IP
