H3C XE 200/2000 IP, Operation Manual

Page: 108 / 514

Operation Manual – Location Server Configuration
H3C XE 200/2000 IP PBX
Chapter 1 Location Server Configuration
1-24
Table 1-37 Configure the information about the gateway manufacturer
Operation Command
Configure the information about the
gateway manufacturer
manufacturer { other | h3c }
Restore the default manufacturer undo manufacturer
The default manufacturer is h3c.
II. Specifying whether to enable multiplexing
Use the multiplex command to specify the multiplexing mode of a gateway registered
with an LS.
Perform the following configuration in LS-GW view.
Table 1-38 Specify whether to enable multiplexing
Operation Command
Specify whether to enable multiplexing multiplex { disable | enable }
Restore the default multiplexing setting undo multiplex
III. Creating a number entry for a subscriber line of a gateway
A number entry for a subscriber line contains one short number and one long number. A
short number starts with a pound sign (#) and is two to three characters in length. It
corresponds to an interface of a gateway, whichever interface it corresponds to
depends on the configuration on the gateway.
Using the subscriber command you can create such an entry on the LS to associate a
short number with a calling/called number (long number). In such a way, you can
configure terminals (such as telephone sets) of a gateway directly on the LS and make
the LS uniformly manage the number resources so as to ease the management burden
of the gateway.
Specifically, when a user makes a call and the called number matches such an entry,
the system directs the call to the called gateway and the corresponding port, and the
called gateway receives the call and directs the call to the corresponding subscriber
line interface. If the called number matches only a route number, the system direct the
call only to the called gateway, which matches the called long number with its number
resource to determine the subscriber line interface corresponding to the called number.
To configure a subscriber line number of a gateway and enter the corresponding
subscriber view, perform the following configuration in LS-GW view.