H3C XE 200/2000 IP, Operation Manual

Page: 115 / 514

Operation Manual – Location Server Configuration
H3C XE 200/2000 IP PBX
Chapter 1 Location Server Configuration
1-31
By default, the default codec type configured on the office device is adopted.
1.4.5 Configuring the Allowed Time Difference between LS and PS/MS
Perform the following configuration in LS view.
Table 1-51 Configure the allowed time difference between LS and PS/MS
Operation Command
Configure the allowed time difference
between LS and PS/MS
heartbeat-time-range time
Restore the default value undo heartbeat-time-range
By default, this value is 0, indicating the time difference is not limited.
1.4.6 Configuring Number Substitution
Refer to the “Feature Operation” module of this manual.
1.5 Displaying and Debugging LS
On the LS, you can view the information about the PSs, GKs, gateways and office
devices configured on the LS, and the CAI message statistics of the LS. Refer to the
Location Server Configuration Command part of H3C XE 200/2000 IP PBX Command
Manual .
I. Displaying the information about PSs registered with an LS
Perform the following configuration in any view.
Table 1-52 Display the information about PSs registered with an LS
Operation Command
Display the information about PSs
registered with an LS display location-server
process-server
{ device-id | all | list }
II. Displaying the information about gateways registered with an LS
Perform the following configuration in any view.
Table 1-53 Display the information about gateways registered with an LS
Operation Command
Display the information about gateways
registered with an LS display location-server gateway
{ device-id | all | h323 | sip | list }