H3C XE 200/2000 IP, Operation Manual

Page: 106 / 514

Operation Manual – Location Server Configuration
H3C XE 200/2000 IP PBX
Chapter 1 Location Server Configuration
1-22
Table 1-32 Configure the status of an office device
Operation Command
Configure the status of an office device device-status { forever | normal }
Note:
The office device state can be configured as normal only when the peer device is also
an XE IP PBX.
XI. Configuring the bearer capability type for an office device
The bearer capability type of an office device indicates the service type (bearer
capability type) supported in the Q.931 header of setup messages sent to the
terminating side when the office device communicates with the trunking gateway.
Perform the following configuration in LS-OFFICEGROUP-OFFICE view.
Table 1-33 Configure the bearer capability type for an office device
Operation Command
Configure the bearer capability type for the
office device
bearer-capability { audio | video }
Restore the default bearer capability type undo bearer-capability
1.4 Advanced Configurations
1.4.1 Enabling/Disabling Random Selection
As for multiple terminals with the same number and priority, if the random selection is
disabled, multiple terminals respond to the call simultaneously; if enabled, the system
selects a terminal randomly in the redirect call mode, while the system randomly
arranges the order of the terminals to have them ring in turn in the routed call mode.
Perform the following configuration in LS view.
Table 1-34 Enable/Disable random selection
Operation Command
Enable random selection policy random-selection enable
Disable random selection policy random-selection disable
Restore the default for the random selection undo policy random-selection