H3C XE 200/2000 IP, Operation Manual

Page: 15 / 514

Operation Manual – Basic Configuration
H3C XE 200/2000 IP PBX
Chapter 2 Command Line Interface for Configuration
2-5
Figure 2-6 Set the dialup number
Figure 2-7 Dial on the remote PC
Step 3: Enter the correct username and password, and proceed to configure or manage
the XE IP PBX when the command line prompt (<XE> for example) appears in the
remote terminal emulation program.
2.1.3 Configuring the XE IP PBX through Telnet
Note:
Before setting up a Telnet connection, make sure that:
z
An IP address has been assigned to the XE IP PBX.
z
VTY login authentication mode and the incoming and outgoing call restriction rules
have been configured.
z
There is a reachable route between the console terminal and the XE IP PBX.