H3C XE 200/2000 IP, Operation Manual

Page: 288 / 514

Operation Manual – System Management
H3C XE 200/2000 IP PBX
Chapter 4 System Maintenance and Management
4-6
Table 4-5 Enable/disable the information center
Operation Command
Enable the information center info-center enable
Disable the information center undo info-center enable
Note:
By default, the information center is enabled.
The system performance may be affected somewhat when the information center is
sorting and producing information, especially when information is enormous.
II. Naming the channels
Perform the following configuration in system view.
Table 4-6 Name a channel
Operation Command
Name a channel info-center channel channel-number name channel-name
The channel-number argument ranges from 0 to 9. The channel-name argument
comprises up to 30 characters except for the characters of “-”, “/”, and “\”.
The system specifies the default names for channels 0 through 5 as shown in the
following table:
Table 4-7 Default names for channels 0 through 5
Channel-number Channel-name
0 console
1 monitor
2 loghost
3 trapbuffer
4 logbuffer
5 snmpagent
III. Information severity
The information center classifies information into eight levels by severity or emergency.
If filtered by severity, the information at a severity level greater than the defined