H3C XE 200/2000 IP, Operation Manual

Page: 441 / 514

Operation Manual – Call Services
H3C XE 200/2000 IP PBX
Chapter 16 Call Pickup Service
16-2
I. Use unilateral call pickup service
Use unilateral call pickup service as follows.
Table 16-1 Use the unilateral call pickup service on the phone
Step Expected result
The XE IP PBX places a call to
subscriber A.
The phone of subscriber A rings.
Subscriber B picks up the phone. Subscriber B hears the dial tone.
Subscriber B dials *11*+ A’s phone
number #.
If subscriber B has the call pickup right,
a call is set up between B and the XE IP
PBX and A’s phone stops ringing.
If B has no call pickup right, B hears the
voice prompt “Sorry, the service is not
available”, and A’s phone keeps ringing.
II. Use bilateral call pickup service
Use the bilateral call pickup service as follows.
Table 16-2 Use the bilateral call pickup service on the phone
Step Expected result
Subscriber A places a call to subscriber
B.
The phone of subscriber B rings.
Subscriber C picks up the phone. Subscriber C hears the dial tone.
C dials *11*+ B’s phone number #.
If subscriber C has the call pickup right,
a call is set up between C and A, and B’s
phone stops ringing.
If C has no call pickup right, it hears the
voice prompt “Sorry, the service is not
available”, and B’s phone keeps ringing.
16.2 Call Pickup Service Configuration
16.2.1 Configuration Procedure
Table 16-3 Configure the call pickup service
Operation Command Description
Enter system view. system-view —
Enter LS view. location-server —
Enter LS-GW view. gateway device-id —