GRAUPNER MX-16S, Programming Manual

Page: 36 / 116

36
The section on pages 18 and 19 explains the basic me-
thod of using the buttons, while the previous doub-
le page explains how to move to the Multi-function list
and reserve a new model memory. At this point we now
wish to start with the “normal” description of the indivi-
dual menu points in the sequence in which they occur
on the transmitter itself. For this reason we start with the
menu …
Model memory
The transmitter can store up to 12 complete sets of mo-
del data, including the digital trim values set by the four
trim levers. The trims are automatically stored, which
means that the settings you have carefully established
through test-fl ying are not lost when you swap models. If
you have entered a model name in the »
Base settings «
menu (pages 38 and 42), the name appears after the
model number.
Use the right-hand rocker button to select the »
Model
memory « menu, and press ENTER or SELECT .
Model memories
Calling up a model, erasing a model, copying model model
Erasing a model
Hold the SELECT button pressed in, use the right-hand
rocker button to select the »clear model« sub-menu,
then press
ENTER or SELECT .
Use the right-hand rocker button to select from the list
the model you wish to erase …
… then press SELECT or ENTER . The program re-
sponds with the security query: “model … to be erased?”
If you answer NO , the process is interrupted, and you
are returned to the previous screen page. If you answer
YES with the right-hand rocker button and confi rm your
choice with ENTER or SELECT , then the selected mo-
del memory is erased.
Caution:
The erasure process is irrevocable. All model memo-
ry data is reset to the factory default settings.
Select model
If you now press the ENTER or SELECT button again,
you move to the »Call up model« sub-menu:
Use the right-hand rocker button to select from the list
the model you wish to use, and confi rm your selection
by pressing
ENTER or SELECT . Pressing ESC takes
you back to the previous menu page without switching
models.
Notes:
• If the warning message “Throttle too high” appears
when you switch models, the throttle stick (C1) is set
towards full throttle and should be moved back to
idle.
• If the message “Set Fail-Safe” appears when you
switch models, you should check your Fail-Safe set-
tings. This only applies if the transmitter is set to
SPCM transmission mode.
• If the battery voltage is too low, it may not be possible
to switch model memories for safety reasons. In this
case the screen displays the following message:
Program description – Model memories