46
Trainer / student
In this menu line you can assign a “transfer switch” for
trainer (trainer / student) mode operations, after pres-
sing
SELECT
or
ENTER
, as described on page 25.
For more information on Trainer systems please refer to
page 110.
Receiver output
For maximum fl exibility in terms of receiver socket as-
signment, the mx-16s program provides the means to
swap over the servo outputs 1 to max. 8; this is carried
out on the second page of the »receiver output« sub-
menu.
Press the
SELECT
or
ENTER
button to move to the
next page of the display. Here you can assign the “con-
trol channels” for servos 1 … 8 to any receiver out-
put you wish to use. However, please note that the dis-
play in »
Servo
display
« – which you can reach by pres-
sing
SELECT
from the basic display – refers exclusively
to the
“control channels”
, i.e. the outputs are
not
swap-
ped over.
With the
SELECT
button held pressed in, use the right-
hand rocker button to select the servo / output combina-
Base settings – Model helicopter
*
GRAUPNER does not guarantee that GRAUPNER radio control sys-
tems will work correctly in conjunction with receiving systems and
radio control equipment made by other manufacturers.
tion you wish to change, then press
ENTER
or
SELECT
.
Now you can assign the desired servo(s) to the selected
output using the right-hand rocker button … or alterna-
tively press
CLEAR
to revert to the default sequence.
Please note that any changes to servo settings, such
as servo travel, Dual Rate / Expo, mixers etc.,
must be
carried out according to the original (default) recei-
ver socket sequence.
Typical applications:
• In the helicopter program of the mx-16s the outputs
for one collective pitch servo and the throttle ser-
vo have been interchanged compared to all earlier
GRAUPNER/JR mc-systems. The throttle servo is
now assigned to receiver output “6” and the collecti-
ve pitch servo to output “1”. You may therefore wish to
retain the earlier confi guration.
• It may also prove necessary to swap servos for Trai-
ner mode operations, if you are using a model set up
for another make * of equipment, to avoid having to
re-connect the servos at the receiver.
Note:
Please note that the Fail-safe “hold-mode” and “position”
programming in SPCM mode always affect the “outputs”,
i.e. the receiver socket numbers; this still applies if you
swap the receiver outputs.
Summary of Contents for MX-16S
