Part No. 147753
S-60 • S-65 • S-60 TRAX • S-65 TRAX
3 - 59
S-60 HC • S-60X • S-60XC
December 2013
Section 3 • Scheduled Maintenance Procedures
16 Install the track assembly onto the drive hub
adapter while guiding the hub adapter studs into
the sprocket of the track assembly. Install as
many sprocket retaining fasteners as possible
to the hub adapter and torque to specification.
Refer to Section 2,
Specifications
.
17 Raise the machine, remove the jack stands and
lower the machine.
18 Drive the machine in either direction just until
the remaining sprocket retaining fasteners can
be installed onto the drive hub adapter. Turn the
machine off.
19 Install the remaining sprocket retaining fasteners
to the drive hub adapter and torque to
specification. Refer to Section 2,
Specifications
.
20 Repeat this procedure for each drive hub.
CHECKLIST
D
PROCEDURES
D-5
Check the Free-wheel
Configuration
Genie specifications require that this procedure be
performed every 1000 hours or annually, whichever
comes first.
Proper use of the free-wheel configuration is
essential to safe machine operation. The
free-wheel configuration is used primarily for towing.
A machine configured to free-wheel without operator
knowledge may cause death or serious injury and
property damage.
Collision hazard. Select a work site
that is firm and level.
Component damage hazard. If the
machine must be towed, do not
exceed 2 mph / 3.2 km/h.
Non-steer end: All Models
1 Chock the steer wheels or tracks (if equipped) to
prevent the machine from rolling.
2 Center a lifting jack of ample capacity
(20,000 lbs / 10,000 kg) under the drive chassis
between the non-steer tires or tracks.
3 Lift the wheels or tracks off the ground and then
place jack stands under the drive chassis for
support.
Summary of Contents for S-60 HC
