Genie S-60 HC, Service Manual

Page: 184 / 461

5 - 4 S-60 • S-65 • S-60 TRAX • S-65 TRAX Part No. 147753
S-60 HC • S-60X • S-60XC
December 2013 Section 5 • Fault Codes
Error Source Error Type Condition Solution
ID Name ID Name
26 Angle sensor 19 Out of range Reduced speed, Power up controller with
cross check required retract into problem corrected
safe envelope
31 Primary 11 Value at 5V Function is Cycle power off,
Ext. / Ret. 12 Value too high inoperative. then on after
Joystick 15 Value too low Alarm sounds problem has been
16 Value at 0V indicating a fault. corrected.
17 Not calibrated Calibrate joystick.
32 Primary 21 Fault Valve is operating Cycle power off,
Ext. / Ret. outside of limits. then on after
Directional Alarm sounds problem has been
Valves indicating a fault. corrected.
33 Primary 12 Value too high Valve is operating Cycle power off,
Ext. / Ret. 15 Value too low outside of limits. then on after
Flow Valve Alarm sounds problem has been
indicating a fault. corrected.
17 Not calibrated Normal function Calibrate valve
except threshold threshold.
for one or both
directions is zero.
34 Ext. Ret. 31 Invalid setup Initiate 1-second beep Fully retract, then lower
Limit Switch of Alarm Buzzer boom
-1000lb. Mode: Check and service ext/
Required retract into ret and fully stowed
“FULLY RETRACTED” switches
state before lowering
-500lb. Mode:
Operates normally
Control System Fault Codes