Genie S-60 HC, Service Manual

Page: 118 / 461

4 - 12 S-60 • S-65 • S-60 TRAX • S-65 TRAX Part No. 147753
S-60 HC • S-60X • S-60XC
December 2013 Section 4 • Repair Procedures
5 Open the bottom bleed screw on the rotator, but
do not remove it.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
6 Move the function enable toggle switch to either
side and hold the platform rotate toggle switch
to the right position until the platform is fully
rotated to the right. Continue holding the toggle
switch until air stops coming out of the bleed
screw. Close the bleed screw.
Crushing hazard. Keep clear of the
platform during rotation.
7 Clean up any hydraulic oil that may have spilled.
8 Rotate the platform fully in both directions and
inspect the bleed screws for leaks.
PLATFORM COMPONENTS
2-3
Platform Overload System,
S-60, S-65, S-60 TRAX and
S-65 TRAX (if equipped)
How to Calibrate the Platform
Overload System
Calibration of the platform overload system is
essential to safe machine operation. Continued use
of an improperly calibrated platform overload
system could result in the system failing to sense
an overloaded platform. The stability of the
machine is compromised and it could tip over.
Note: For S-60 HC models, refer to Repair
Procedure
2-4, Platform Load Sense System,
S-60 HC.
Note: Perform this procedure with the machine on a
firm, level surface.
1 Turn the key switch to platform control. Start the
engine and level the platform.
2 Determine the maximum platform capacity.
Refer to the machine serial plate.
3 Remove all weight, tools and accessories from
the platform.
Note: Failure to remove all weight, tools and
accessories from the platform will result in an
incorrect calibration.
4 Using a suitable lifting device, place a test
weight equal to the maximum platform capacity
at the center of the platform floor.