Genie S-60 HC, Service Manual

Page: 62 / 461

3 - 24 S-60 • S-65 • S-60 TRAX • S-65 TRAX Part No. 147753
S-60 HC • S-60X • S-60XC
December 2013 Section 3 • Scheduled Maintenance Procedures
3 Remove the fasteners from the engine side
cover, then remove the cover.
4 Inspect the oil cooler for leaks and physical
damage.
a oil cooler
b cylinder head cooling fins
c fan blower fins
5 Clean the oil cooler of debris and foreign
material.
Cooling and fan blower fins:
6 Inspect the fan blower fins for physical damage.
7 Clean the fan blower fins of debris and foreign
material.
8 Inspect the head cooling passages and fins for
physical damage or foreign material, using a
flashlight.
9 Clean the cylinder head cooling passages of
debris and foreign material.
10 Install the engine side cover.
11 Swing the engine back to its original position
and install the engine pivot plate retaining
fastener.
B-6
Inspect the Tires, Wheels and
Lug Nut Torque, S-60, S-65,
S-60 HC, S60X and S-60XC
Genie specifications require that this procedure be
performed every 250 hours or quarterly, whichever
comes first.
Maintaining the tires and wheels, including proper
wheel fastener torque, is essential to safe operation
and good performance. Tire and/or wheel failure
could result in a machine tip-over. Component
damage may also result if problems are not
discovered and repaired in a timely fashion.
Bodily injury hazard. An over-
inflated tire can explode and could
cause death or serious injury.
Tip-over hazard. Do not use
temporary flat tire repair products.
Note: The tires on some machines are foam-filled
and do not need air added to them.
1 Check all tire treads and sidewalls for cuts,
cracks, punctures and unusual wear.
2 Check each wheel for damage, bends and
cracked welds.
3 Check each lug nut for proper torque.
Refer to Section 2, Specifications .
4 Check the pressure in each air-filled tire.
Refer to Section 2, Specifications .
CHECKLIST B PROCEDURES
c b a