Genie S-60 HC, Service Manual

Page: 145 / 461

Part No. 147753 S-60 • S-65 • S-60 TRAX • S-65 TRAX 4 - 39
S-60 HC • S-60X • S-60XC
December 2013 Section 4 • Repair Procedures
ENGINES
How to Install a Type "A"
Flex Plate
1 Install the flex plate onto the engine flywheel
with the raised spline towards the pump.
2 Ford models: Torque the flex plate mounting
bolts in sequence to 14 ft-lbs / 19 Nm.
Then torque the flex plate mounting bolts in
sequence to 20 ft-lbs / 27 Nm.
Deutz models: Torque the flex plate mounting
bolts in sequence to 28 ft-lbs / 38 Nm.
Then torque the flex plate mounting bolts in
sequence to 40 ft-lbs / 54 Nm.
Perkins models:
Torque the flex plate mounting
bolts in sequence to 49 ft-lbs / 66 Nm.
Then torque the flex plate mounting bolts in
sequence to 70 ft-lbs / 95 Nm.
Ford and Deutz models
Perkins models
3 Install the pump coupler onto the pump shaft
with the set screw toward the pump. Leave the
appropriate gap between coupler and pump end
plate for your engine.
a pump
b pump shaft
c pump coupler
d flex plate with raised spline
e engine flywheel
f
3
/
16
inch / 4.8 mm gap - Diesel Models
0.080 inch / 2 mm gap - Ford Models
4 Apply Loctite
®
removable thread sealant to the
pump coupler set screw. Torque the set screw
to 61 ft-lbs / 83 Nm.
5 Proceed to Repair Procedure, How to Install the
Pump and Bell Housing Assembly.
1
2
3
4
5
6
1
2
3
a b c d e
f