4 - 16
S-60 • S-65 • S-60 TRAX • S-65 TRAX
Part No. 147753
S-60 HC • S-60X • S-60XC
December 2013
Section 4 • Repair Procedures
6 Start the engine from the ground controls.
7 Raise the boom until the distance, when
measured between the centers of the pivot pins
shown, equals 108.75 inches / 276 cm
± 0.75 inch / 19 mm.
Crushing hazard. Keep clear of all
moving parts of the boom while the
boom is raising. Do not attempt to
measure between the pivot pins
while the boom is moving.
PLATFORM COMPONENTS
8 Activate the calibration toggle switch inside the
ground control box 1 time.
Result: The alarm should sound for 1 second
indicating the second calibration step was
accepted. The green LED on the operational
controller should be blinking fast and the red
LED should be blinking three times indicating
that step 3 of calibration is next.
9 Raise the boom until the distance, when
measured between the centers of the pivot pins
shown, equals 167.25 inches / 424.8 cm
± 0.75 inch / 19 mm.
Crushing hazard. Keep clear of all
moving parts of the boom while the
boom is raising. Do not attempt to
measure between the pivot pins
while the boom is moving.
10 Activate and release the calibration toggle
switch inside the ground control box 1 time.
Result: The alarm should sound for 1 second
indicating the third calibration step was
accepted. The green LED on the operational
controller should be blinking fast and the red
LED should be blinking four times indicating that
step 4 of calibration is next.
11 Fully raise and extend the boom.
Measure between
the centers of these
pivot pins
Operational Control Module LED Status
Description
Definition
Green AND Red LED's
System calibrated
not
flashing
Green LED
System in calibration
flashing rapidly
mode
Red LED flashing
Indicates next calibration
with pauses
step (ie; 2, 3, etc.)
Safety Control Module LED Status
Description
Definition
Green AND Red LED's
System calibrated
not
flashing
Green AND Red LED's
System not calibrated
flashing alternately
Summary of Contents for S-60 HC
