Genie S-60 HC, Service Manual

Page: 205 / 461

Part No. 147753 S-60 • S-65 • S-60 TRAX • S-65 TRAX 5 - 25
S-60 HC • S-60X • S-60XC
December 2013 Section 5 • Fault Codes
Error Source 31, Boom Angle Operational Sensor (C123PBS)
Error Type
Condition Solution
ID Name
5 Sensor tolerance fault Power relays disengaged. Repair wiring and/or connections OR
replace boom angle sensor and calibrate
overload system.
11 Output short high Power relays disengaged. Repair wiring and/or connections
Boom angle sensor OR replace boom angle sensor
wiring open or shorted and calibrate overload system.
to voltage.
12 Value too high Power relays disengaged. Repair wiring and/or connections
Boom angle sensor wiring OR adjust or replace boom angle sensor
open or shorted to voltage and calibrate overload system.
OR sensor is out of
operating range.
15 Value too low Power relays disengaged. Repair wiring and/or connections
Boom angle sensor wiring OR adjust or replace boom angle sensor
open OR shorted to ground and calibrate overload system.
OR sensor is out of
operating range.
16 Output short low Power relays disengaged. Repair wiring and/or connections
Boom angle sensor wiring OR replace boom angle sensor
open OR shorted to ground. and calibrate overload system.
17 Not calibrated Boom range of Calibrate the platform load sense
motion is limited. system.
18 Just calibrated Used to clear Self-clearing.
diagnostic codes.
Load Sense System Fault Codes