Genie S-60 HC, Service Manual

Page: 95 / 461

Part No. 147753 S-60 • S-65 • S-60 TRAX • S-65 TRAX 3 - 57
S-60 HC • S-60X • S-60XC
December 2013 Section 3 • Scheduled Maintenance Procedures
8 Fully retract the boom and raise the boom to full
height. Visually inspect the dial indicator to be
sure the needle returns to the "zero" position.
9 Remove the dial indicator and rotate the
turntable 90°.
10 Repeat steps 4 through 9 until the rotation
bearing has been checked in at least four
equally spaced areas 90° apart.
11 Lower the boom to the stowed position and turn
the machine off.
12 Remove the dial indicator from the machine.
D-4
Replace the Drive Hub Oil
Genie specifications require that this procedure be
performed every 1000 hours or annually, whichever
comes first.
Replacing the drive hub oil is essential for good
machine performance and service life. Failure to
replace the drive hub oil at yearly intervals may
cause the machine to perform poorly and continued
use may cause component damage.
S-60, S-65, S-60 HC, S-60X and S-60XC:
1 Select the drive hub to be serviced. Drive the
machine until one of the two plugs is at the
lowest point.
2 Remove both plugs and drain the oil into a
suitable container.
3 Drive the machine until both plugs are
horizontal.
a drive hub plugs
4 Fill the hub until the oil level is even with the
bottom of the plug hole. Refer to Section 2,
Specifications.
5 Install the plugs into the drive hub.
6 Check the torque of the drive hub mounting
bolts. Refer to Section 2, Specifications .
7 Repeat this procedure for each drive hub.
CHECKLIST D PROCEDURES
a