Genie S-60 HC, Service Manual

Page: 88 / 461

3 - 50 S-60 • S-65 • S-60 TRAX • S-65 TRAX Part No. 147753
S-60 HC • S-60X • S-60XC
December 2013 Section 3 • Scheduled Maintenance Procedures
C-6
Replace the Engine Air Filter
Element - Deutz and Perkins
Models
Engine specifications require that this procedure be
performed every 500 hours or every six months,
whichever comes first.
Maintaining the engine air filter in good condition is
essential to good engine performance and service
life. Failure to perform this procedure can lead to
poor engine performance and component damage.
Note: Perform this procedure with the engine off.
1 Locate the engine air filter assembly.
2 Release the latches from the air cleaner canister
end cap. Remove the end cap.
3 Remove and discard the filter element.
4 Clean the inside of the canister and the end cap
with a damp cloth.
5 Install the new filter element.
6 Install the air filter canister end cap and secure
the end cap latches.
CHECKLIST C PROCEDURES
C-7
Check the Safety Envelope Limit
Switches and Angle Sensor,
S-60X and S-60XC
Genie specifications require that this procedure be
performed every 500 hours or six months,
whichever comes first.
Testing the safety envelope system regularly is
essential to safe machine operation. Continued use
of an improperly operating safety envelope could
result in the system not restricting the range of
motion. Machine stability could be compromised
resulting in the machine tipping over.
Note: Perform this procedure with the machine on a
firm, level surface with all weight, tools and
equipment removed from the platform.
Note: Start this procedure with the boom fully
retracted and in the stowed position.
Ground controls:
1 Turn the key switch to ground control and pull
out the red Emergency Stop button to the on
position.
2 Start the engine from the ground controls.