Genie S-60 HC, Service Manual

Page: 183 / 461

Part No. 147753 S-60 • S-65 • S-60 TRAX • S-65 TRAX 5 - 3
S-60 HC • S-60X • S-60XC
December 2013 Section 5 • Fault Codes
Control System Fault Codes
Error Source Error Type Condition Solution
ID Name ID Name
21 Primary Up / Down 11 Value at 5V Function is Cycle power off,
Joystick 12 Value too high inoperative. then on after
15 Value too low Alarm sounds problem has been
16 Value at 0V indicating a fault. corrected.
17 Not calibrated Calibrate joystick.
22 Primary 21 Fault Valve is operating Cycle power off,
Up / Down outside of limits. then on after
Directional Alarm sounds problem has been
Valves indicating a fault. corrected.
23 Primary 12 Value too high Valve is operating Cycle power off,
Up / Down 15 Value too low outside of limits. then on after
Flow Valve Alarm sounds problem has been
indicating a fault. corrected.
17 Not calibrated Normal function Calibrate valve
except threshold threshold.
for one or both
directions is zero.
24 Angle sensor 11 Value at 5V Reduced speed Cycle power off,
12 Value too high function. then on after
15 Value too low Alarm sounds problem has been
16 Value at 0V indicating a fault. corrected.
17 Not calibrated Calibrate angle sensor.
31 Invalid setup Initiate 1 -second Calibrate angle sensor.
beep of Alarm Buzzer
and required retract
into safe envelope