Genie S-60 HC, Service Manual

Page: 28 / 461

2 - 6 S-60 • S-65 • S-60 TRAX • S-65 TRAX Part No. 147753
S-60 HC • S-60X • S-60XC
Section 2 • Specifications December 2013
SPECIFICATIONS
Ford MSG-425 EFI Engine
Displacement 152.5 cu in
2.5 liters
Number of cylinders
4
Bore & stroke
3.50 x 3.94 inches
89 x 100 mm
Horsepower 60 @ 2500 rpm
44.7 kW @ 2500 rpm
Firing order 1 - 3 - 4 - 2
Low function idle (computer controlled) 1600 rpm
53.3 Hz
High function idle (computer controlled) 2500 rpm
83.3 Hz
Compression ratio 9.7:1
Compression pressure (approx.)
Pressure (psi or bar) of lowest cylinder must be
at least 75% of highest cylinder
Lubrication system
Oil pressure 29 to 39 psi
(at operating temperature @ 2500 rpm) 2 to 2.7 bar
Oil capacity 6.7 quarts
(including filter) 6.4 liters
Oil pressure switch
Oil pressure switch point 7 to 9 psi
0.48 to 0.62 bar
Oil viscosity requirements
Extreme operating temperatures may require the use of
alternative engine oils. For oil requirements, refer to the
Engine Operator Handbook on your machine.
Electronic fuel pump
Fuel pressure, static 60 psi
4.1 bar
Fuel flow rate 0.43 gpm
1.6 L/min
Fuel requirement
For fuel requirements, refer to the engine Operator's
Manual on your machine.
Ignition system
Spark plug type Motorcraft AYFS-32Y-R
Spark plug gap 0.049 to 0.053 inches
1.25 to 1.35 mm
Engine coolant
Capacity 10 quarts
9.5 liters
Cylinder head temperature sending unit
Fault code set temperature 280°F
138°C
Engine shut-down temperature 300°F
149°C
Starter motor
Normal engine cranking speed 200 to 250 rpm
Current draw, normal load 140-200A
Current draw, maximum load 800A
Alternator
Output 95A, 13.8V DC
Battery
Type 12V DC, Group 31
Quantity 1
Cold cranking ampere @ 0°F 1000A
Reserve capacity @ 25A rate 200 minutes
Continuous improvement of our products is a
Genie policy. Product specifications are subject
to change without notice.