Genie S-60 HC, Service Manual

Page: 75 / 461

Part No. 147753 S-60 • S-65 • S-60 TRAX • S-65 TRAX 3 - 37
S-60 HC • S-60X • S-60XC
December 2013 Section 3 • Scheduled Maintenance Procedures
3 Thoroughly clean the outside surfaces of the
fuel filter assembly.
4 Place a suitable container under the fuel filter
element.
5 Disconnect and plug the fuel line from the fuel
pump to the fuel filter element.
a fuel line
b filter head
c fuel filter element
6 Remove the fuel filter element with a filter
wrench.
7 Apply a thin layer of fuel to the new fuel filter
element O-ring.
8 Install the new fuel filter element and tighten it
securely by hand. Clean up any fuel that may
have spilled during the installation procedure.
9 Use a permanent ink marker to write the date
and number of hours from the hour meter on the
oil filter housing.
CHECKLIST B PROCEDURES
Bleed the fuel system:
10 Loosen the vent plug on top of the fuel injection
pump.
a vent plug
b fuel injection pump
c fuel lift pump
11 Operate the priming lever or priming bulb (if
equipped) of the fuel lift pump until fuel, free
from air, comes from the vent plug. Tighten the
vent plug.
12 Clean up any fuel that may have spilled during
this procedure.
13 Operate the starter motor for intervals of 15
seconds until the engine starts.
14 Swing the engine back to its original position
and install the engine pivot plate retaining
fastener.
Note: It is important to allow the starter motor to
cool for 30 seconds between each 15 second
interval of operation.
Note: If the engine runs correctly for a short time
and then stops or runs roughly, check for air in the
fuel system. If there is air in the fuel system, there
is probably a leak in the low pressure side of the
system.
b
a
c
a
b
c