Genie S-60 HC, Service Manual

Page: 147 / 461

Part No. 147753 S-60 • S-65 • S-60 TRAX • S-65 TRAX 4 - 41
S-60 HC • S-60X • S-60XC
December 2013 Section 4 • Repair Procedures
How to Install the Pump and Bell
Housing Assembly
1 Install the pump and bell housing assembly.
Deutz models: Torque the bell housing
mounting bolts labeled "C" in sequence to 28 ft-
lbs / 38 Nm. Then torque the bell housing
mounting bolts labeled "C" in sequence to 40 ft-
lbs / 54 Nm.
Ford models: Torque the bell housing mounting
bolts labeled "A" and "B" in sequence to 28 ft-
lbs / 38 Nm and the mounting bolts labeled "C"
to 49 ft-lbs / 66 Nm. Then torque the bell
housing mounting bolts labeled "A" and "B" in
sequence to 40 ft-lbs / 54 Nm and the mounting
bolts labeled "C" to 70 ft-lbs / 95 Nm.
Perkins models:
Torque the bell housing
mounting bolts labeled "B" in sequence to
28 ft-lbs / 38 Nm and the mounting bolts labeled
"A" to 49 ft-lbs / 66 Nm. Then torque the bell
housing mounting bolts labeled "B" in sequence
to 40 ft-lbs / 54 Nm and the mounting bolts
labeled "A" to 70 ft-lbs / 95 Nm.
Component damage hazard.
Type "A" flexplate: When
installing the pump, do not force
the pump coupler into the flexplate
or damage to the pump shaft seal
may occur.
Component damage hazard. Do
not force the drive pump during
installation or the flex plate teeth
may become damaged.
Deutz models
Ford models
Perkins models
ENGINES
10
6
1
8
4
11
7
5
9
2
12
3
C
C C
C
C
C
C
C
C
C
C
C
6 1
9
5
7
3
2
8
4
A A
B
B
B
B
B
B
B
C
C
B
B
A
A
B
1
2
3
4
5
6
7