Genie S-60 HC, Service Manual

Page: 99 / 461

Part No. 147753 S-60 • S-65 • S-60 TRAX • S-65 TRAX 3 - 61
S-60 HC • S-60X • S-60XC
December 2013 Section 3 • Scheduled Maintenance Procedures
12 Re-engage the drive hubs by turning over
the hub disconnect caps. Rotate each wheel or
track to check for engagement. Raise the
machine, remove the jack stands and lower the
machine.
Collision hazard. Failure to
re-engage the drive hubs may
cause death or serious injury and
property damage.
D-6
Replace the Hydraulic Filters
Genie requires that this procedure be performed
every 1000 hours or annually, whichever comes
first. Perform this procedure more often if dusty
conditions exist.
Replacement of the hydraulic filters is essential for
good machine performance and service life. A dirty
or clogged filter may cause the machine to perform
poorly and continued use may cause component
damage. Extremely dirty conditions may require
that the filters be replaced more often.
Bodily injury hazard. Beware of hot
oil. Contact with hot oil may cause
severe burns.
Note: Perform this procedure with the engine off.
Hydraulic return filter:
1 Open the ground controls side turntable cover
and locate the hydraulic return filter housing on
top of the hydraulic tank.
2 Remove the cap from the filter housing.
3 Lift the handle on the filter element and rotate
the element counterclockwise to release the
element from the housing.
4 Remove the filter element from the filter
housing.
CHECKLIST D PROCEDURES
disengaged position
engaged position