GE LOGIQ A100, Technical Publication

Page: 122 / 408

Basic Measurements
106
LOGIQ
t α
100 User Manual
2211157–100 Rev 0
Two Distance Method (cont.)
Use the TRACKBALL to move the second cursor to the
measurement end point.
Press SET to fix the end point of cursor. The distance
measured by this pair of calipers appears on the left side
of the screen. Simultaneously a second open ended
“ ” cursor appears on the screen.
Use the TRACKBALL to move the open ended “ ” cursor
to either end of the second axis of the area to measure.
Press SET to fix the start point cursor. Distance in mm
appears on the left side of the screen.
Use the TRACKBALL to move the second “ ” cursor to
the measurement end point.
Press
SET to fix the end point of cursor.
The circumference and area is calculated and displayed
on the left side of the screen.
Should further measurements need to be taken, press
SET again to invoke a fifth cursor and follow the
procedure above.
Four Circumference/Area measurements can be
displayed at the same time.
TB
TB
TB