Garmin G1000 NXi, Reference Manual

Page: 223 / 260

Garmin G1000 NXi Cockpit Reference Guide for the Cessna NAV III 190-02178-02 Rev. A
197
Annunciations & Alerts
Flight
Instruments
EIS
Nav/Com/
XPDR/Audio
Flight
Management
Hazar
d
Avoidance
AFCS
Additional
Featur
es
Abnormal
Oper
ation
Annun/Alerts
Appendix
Index
Message Comments
GEA1 INOP - INTRL
– GEA internal
fault.
GEA 1 has an internal fault. The system should
be serviced.
GEA1 INOP - SENS – Check GEA
configuration.
There is an error in the GEA 1 configuration.
Check the configuration. If the problem persists,
the system should be serviced.
GEA1 INOP - TEMP – Check GEA
cooling arrangement.
The GEA 1 configuration module has insufficient
cooling. If the problem persists, the system
should be serviced.
GEA1 INOP - VOLT – Check GEA
voltages.
The GEA 1 voltage is low. Check GEA voltages.
GEA1 INSP RQRD – Redundant power
supply is not present.
The GEA 1 redundant power supply is not
present. Check the connection.
GEA1 MANIFEST – GEA1 software
mismatch, communication halted.
The #1 GEA 71 has incorrect software installed.
The system should be serviced.
GEO LIMITS
– AHRS1 too far North/
South, no magnetic compass.
The aircraft is outside geographical limits for
approved ADAHRS operation. Heading is
flagged as invalid.
GFC MANIFEST
– GFC software
mismatch, communication halted.
Incorrect servo software is installed, or gain
settings are incorrect.
GIA #[1, 2] INOP
– CRNT - Check GIA
current.
GIA1 and/or GIA2 current is low. Check GIA
current.
GIA #[1, 2] INOP - SERL
– Check GIA
Serial Communication.
The GIA1 and/or GIA2 communication is
inoperative. They system should be serviced.
GIA #[1, 2] INOP - VOLT – Check GIA
voltages.
The GIA1 and/or GIA2 voltage is low. Check
GIA voltages.
GIA1 CONFIG – GIA1 audio config
error. Config service req’d.
The GIA1 have an error in the audio
configuration. The system should be serviced.
GIA1 CONFIG
– GIA1 config error.
Config service req’d.
The GIA1 configuration settings do not match
backup configuration memory. The system
should be serviced.
GIA1 COOLING – GIA1 temperature
too low.
The GIA1 and/or GIA2 temperature is too low
to operate correctly. Allow units to warm up to
operating temperature.