Garmin G1000 NXi, Reference Manual

Page: 222 / 260

Garmin G1000 NXi Cockpit Reference Guide for the Cessna NAV III 190-02178-02 Rev. A
196
Annunciations & Alerts
Flight
Instruments
EIS
Nav/Com/
XPDR/Audio
Flight
Management
Hazar
d
Avoidance
AFCS
Additional
Featur
es
Abnormal
Oper
ation
Annun/Alerts
Appendix
Index
Message Comments
G/S1 SERVICE
– G/S1 needs service.
Return unit for repair.
A failure has been detected in glideslope
receiver 1. The receiver may still be available.
The system should be serviced when possible.
G/S2 FAIL
– G/S2 is inoperative. A failure has been detected in glideslope
receiver 2. The system should be serviced.
G/S2 SERVICE – G/S2 needs service.
Return unit for repair.
A failure has been detected in glideslope
receiver 2. The receiver may still be available.
The system should be serviced when possible.
GDC1 MANIFEST – GDC1 software
mismatch, communication halted.
The ADAHRS has incorrect software installed.
The system should be serviced.
GDL69 CONFIG – GDL 69 config error.
Config service req’d.
GDL 69/69A SXM configuration settings do not
match those of backup configuration memory.
The system should be serviced.
GDL69 FAIL – GDL 69 has failed. A failure has been detected in the GDL
69/69A or GDL 69/69A SXM. The receiver is
unavailable. The system should be serviced.
GDL69 MANIFEST – GDL software
mismatch, communication halted.
The GDL 69/69A SXM has incorrect software
installed. The system should be serviced.
GEA1 CM INOP - COMM – Check
GEA config module connection.
There is a problem with the GEA 1 config
module connection. Check the connection.
GEA1 CM INOP - TEMP
– Check GEA
config module cooling.
The GEA 1 configuration module has insufficient
cooling. If the problem persists, the system
should be serviced.
GEA1 CONFIG
– GEA1 config error.
Config service req’d.
The GEA1 configuration settings do not match
those of backup configuration memory. The
system should be serviced.
GEA1 INOP- CAL
– Check GEA
rigging.
There is a problem with the GEA 1 rigging.
Check the rigging.
GEA1 INOP - CNFG
– Check GEA
software and configuration.
There is a problem with the GEA 1 software
configuration. Check the configuration. If the
problem persists, the system should be serviced.