Fujitsu SPARC Enterprise M3000, Xscf Reference Manual, Page: 535 / 560

testsb(8)
System Administration 511
■
XSB is installed in the domain and this domain is in OpenBoot PROM (
ok>
prompt) status.
■
XSB is installed in the domain and this domain is power ON status, power
OFF status, or reboot status.
■
The
addboard
(8),
deleteboard
(8), or
moveboard
(8) command is executed
for XSB.
■
In case an XSB which belongs to the specified PSB is in
Unmount
or
Faulted
status, it may be excluded from the target of diagnosis and may not be shown in
the diagnosis result. In a case like this, use the
showboards
(8) command to
check the diagnosis result.
■
In case there are the settings for the warm-up time of the system and the wait
time before system startup, a prompt appears to confirm whether or not it can
ignore these settings to execute the
testsb
(8) command. Enter "
y
" to execute the
command or "
n
" to cancel the command.
■
The displayed diagnostic results of the
testsb
(8) command are as follows:
XSB
XSB numbers belonging to the specified PSBs. One XSB number
is displayed for the Uni-XSB type, and four XSB numbers are
displayed for the Quad-XSB type.
Test
Status of the initial diagnosis of XSBs. One of the following status
values is displayed:
Unmount
No XSB could be recognized because no XSB
is mounted or because an error occurred.
Unknown
Not tested.
Testing
Initial diagnosis is in progress.
Passed
Initial diagnosis ended normally.
Failed
An error was detected during the initial
diagnosis. An XSB cannot be used or is in a
degraded state.
Fault
XSB error. One or more states are displayed:
Normal
Normal state.
Degraded
One or more components are degraded. Each
XSB can operate.
Faulted
An XSB cannot operate because an error
occurred.