Fujitsu SPARC Enterprise M3000, Xscf Reference Manual, Page: 288 / 560

setprivileges(8)
264 SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised September 2008
OPERANDS
The following operands are supported:
domainprivilege
@
domains
Specifies
domainadm
,
domainmgr
, or
domainop
privileges for a specific
domain or domains.
The following are valid values for domainprivilege , each of which must be
used with
@
domains :
domainadm
Can perform all operations and view status on the
hardware assigned to the domains on which this
privilege is held (assign, unassign, power, and so on).
Can perform all operations on domains on which this
privilege is held. Can view all states of domains on
which this privilege is held.
domainmgr
Can reboot and power on and off all domains on which
this privilege is held. Can view all states of all hardware
assigned to the domains on which this privilege is held.
Can view all states of domains on which this privilege is
held.
domainop
Can view all states of all the hardware assigned to the
domains on which this privilege is held. Can view all
states of all domains on which this privilege is held.
domains Specifies a domain or domains, using the appropriate
value for
domainprivilege with the
@
symbol and the
domains descriptor:
To specify a single domain, use the
@
symbol followed
by a single domain number. Example:
domainadm@3
.
To specify a range of domains, use a "
–
" to indicate to
start and end of the domains in the range, inclusive.
Example:
domainadm@3–4
.
To specify multiple single domains and multiple domain
ranges, separate the domains or domain ranges with
commas. Do not repeat domains or cause them to
overlap or an error will result. Example:
domainadm@1–
2,4
.
privileges