Fujitsu Server PRIMERGY TX1330 M1, Upgrade And Maintenance Manual

Page: 112 / 336

112 Upgrade and Maintenance Manual
TX1330 M1
Power supply
I
Note for servers using CMA (Cable Management Arm)
Regarding of replacing power supply units, additional tasks are needed,
due to an interference between CMA stopper and the power supply units.
Ê
Unlock the CMA stopper.
Ê
Remove the CMA stopper with the mounted crossbar.
Ê
Support the CMA stopper, the crossbar and the CMA including cables
with your right hand.
Ê
Remove the power supply unit and install the new power supply unit
carefully.
Ê
Remount the complete assembly (CMA stopper, crossbar and CMA)
into the rail.
6.3.3.1 Preliminary steps
Ê
"Locating the defective server" on page 43
Ê
Only when replacing a power supply unit in a non-redundant configuration:
"Shutting down the server" on page 46
Ê
Only when replacing a power supply unit in a non-redundant configuration:
"Disconnecting the server from the mains" on page 46
6.3.3.2 Removing the defective hot-plug power supply unit
Ê
Identify the defective power supply unit using the server management
software.
Ê
Remove the power supply unit as described in "Removing a hot-plug power
supply unit" on page 110 .
6.3.3.3 Installing the new hot-plug power supply unit
Ê
Install the power supply unit as described in section "Installing a hot-plug
power supply unit" on page 108 .