Fuji Xerox ApeosPort 350 I, User Manual

Page: 574 / 609

17 Appendix
572
Appen
d
ix
17
If the following data is entered when the scaling mode = paper size, origin position =
Auto, paper margin is 10mm, area determination mode = IP:
All pen width settings are 0.1 mm
The following data does not contain a character size specification command and the
physical size of the area specified by IP/IW is A3.
IN;
IP-8399,-5938, 8399, 5938;
IW-8399,-5938, 8399, 5938;
PU;
SP1;
:
:
SP0;
1) As the area determination mode is IP, the ACA is specified as the area -8399,-
5938,8399,5938 by an IP command.
YYY
2) In the example above, as there are no font size specification commands and all the
pen widths are 0.1 mm, add the height/2 of the default font size for A3 size paper
(75 plotter units) to the ACA obtained in
1
.
The ACA obtained in
2
is
-8474,-6013,8474,6013
.
3) The value set in paper margins (10 mm = 400 plotter units) is subtracted from the
ACA obtained in
2
.
The ACA obtained in
3
is
-8074,-5613,80740,5613
.
4) As the ACA obtained in
3
exceeds the A4 size and is A3 size, the document size is
determined to be A3.
In addition, as the ACA area when the paper margin setting is 0 mm is
8474,-6013,
8474,6013
, and this exceeds A3, but is A2 or smaller, the document size is
determined to be A2.
5. How to Determine Paper Size
If the operation panel settings are as follows, the paper size is determined as below.
Document size: Auto
Paper Tray: Auto
The method for determining the paper size differs according to the paper size and
scaling mode settings on the operation panel.
„ If the Paper Size Setting is A Sizes
The possibilities for paper size are those that are actually loaded in the trays, from
among the three sizes, A3, A4 and A5.
If A-sized papers (A3, A4, A5) are not loaded in the trays, all of the sizes, A3, A4 and
A5 become possible sizes; a message is displayed on the operation panel prompting
the user to load A-sized paper.
„ If the Paper Size Setting is Auto
The possibilities for paper size are those that are actually loaded in the trays, from
among the 5 sizes, A3, B4, A4, B5 and A5.
If A3, B4, A4, B5 or A5 paper is not loaded in the trays, all of the sizes become possible
sizes; a message is displayed on the operation panel prompting the user to load paper.