Fuji Xerox ApeosPort 350 I, User Manual

Page: 294 / 609

11 System Settings
292
System Settin
gs
11
Memory Full Procedure
When the space of the hard disk runs out during scanning originals, a screen appears
asking how the partly stored data should be handled.
Once a certain time has elapsed with the confirmation screen displayed, the
subsequent processing is determined by these settings.
You can set the time until the memory full procedure is carried out. For more information, refer to "Auto
Job Release" (P.266).
„ Cancel Job
The stored data is discarded.
„ Run Job
The read-in data is treated as valid, and the part of the original read in is copied.
Maximum Stored Pages
Set the maximum number of stored pages of a copy original. You can set a number
from 1 to 999 pages.
Auto Paper Off
Select the tray used when [Auto] of [Paper Supply] in the [Basic Copying] screen is
canceled (the tray used when [Auto] of [Paper Supply] is selected in the [Basic
Copying] screen, and [Auto %] or [Independent X-Y%] is selected for [Reduce/
Enlarge]).
Mixed Size Originals - Copy to Side 2
When the size of the side 1 differs from that of the side 2 in 2-sided copy, if different
size of originals for side 1 and side 2 are selected by automatic paper supply, sets the
paper to copy side 2 of the original.
Important • When the side 1 and side 2 are different sizes and if the side 2 is copied on the sheet on
which the side 1 has already been printed, an image may be missing.
„
Off (Copy to new sheet)
Side 2 is copied on the front of a new sheet.
„ On
Side 2 is copied on the opposite side of Side 1 without changing the paper size.
Fine-tune 100%
Tune the magnification finely when copying at 100% (actual size). The set value is
applied when [Reduce/Enlarge] or [Preset %] on the [Basic Copying] screen is set to
100%.
Set the value in the X/Y directions within the range 98 to 102% in 0.1% increments.
Important • This feature is applied only when a copy is made by the document glass. Moreover, it is not
reflected in the magnification (100%) set by [Variable %], [Independent X-Y%] and
[Calculator %].
Note • A magnification displays [100%] even if [Fine-tune 100%] is set.
1
Select [Fine-tune 100%], and
select [Change Settings].
2
Enter the magnification using [ ],
[ ], [ ], and [ ].