Festo CMMD-AS series, Description

Page: 218 / 246

A Diagnostic messages
218 Festo – GDCP-CMMS/D-FW-EN – 1404NH – English
Error group 04 Temperature monitoring, electronics
No. Code Message Reaction
04-0
4210h
Excess/low temperature of power electronics
configurable
Cause Motor controller is overheated.
– Motor controller overloaded?
– Temperature display plausible?
Action • Check installation conditions, cooling through the housing
surface, integrated heat sink and back wall.
• Check the drive layout (due to possible overloading in continu-
ous operation).
Error group 05 Internal power supply
No. Code Message Reaction
05-0 5114h 5 V electronics supply fault PS off
Cause Monitoring of the internal power supply has recognised under-
voltage. This is either due to an internal defect or an overload/
short circuit caused by connected peripherals.
Action • Separate device from the entire peripheral equipment and
check whether the error is still present after reset. If so, an
internal defect is present Repair by the manufacturer.
05-1 5115h Error in 24 V supply PS off
Cause Monitoring of the internal power supply has recognised under-
voltage.
Action • Check 24 V logic supply.
• Separate device from the entire peripheral equipment and
check whether the error is still present after reset. If so, an
internal defect is present Repair by the manufacturer.
05-2 5116h 12 V electronics supply fault PS off
Cause CMMS-ST only:
Monitoring of the internal power supply has recognised under-
voltage. This is either due to an internal defect or an overload/
short circuit caused by connected peripherals.
Action • Separate device from the entire peripheral equipment and
check whether the error is still present after reset. If so, an
internal defect is present Repair by the manufacturer.
05-2 8000h Driver supply error/driver supply failed PS off
Cause Only CMMS-AS/CMMD-AS:
Error in the plausibility check of the driver supply (safe torque off )
Action • Separate device from the entire peripheral equipment and
check whether the error is still present after reset. If so, an
internal defect is present Repair by the manufacturer.