EXFO MAX-800 Series, User Manual

Page: 106 / 495

Test Setup - Test Configurator, Timer, and System
98
MAX-800 Series
EtherSAM - Burst
Parameters

Number of Burst Sequence is the number of times, 1 to 100 (default
is
2
), the burst sequence will be repeated for the CBS and EBS tests.

Refill Delay Ratio (%) is the percentage of time required to refill the
CBS/EBS
token buckets. The refill delay ratio is used for post-burst
delay and the remaining percentage is applied to the pre-burst delay.
The
Refill Delay Ratio
is configurable from
0
to
100
percent
( 50 percent is the default as well as the standard’s minimum
recommended value).

Burst/IR Frame Ratio (%) is the percentage of frames transmitted at
CIR
rate for the
CBS
test and the percentage of frames transmitted at
CIR+EIR rate for the EBS test. The Burst/IR Frame Ratio is
configurable from
10
to
90
percent (
90
percent is the default as well as
the standard’s recommended percentage value).
Table
Note: Test time values are only displayed for enabled services.

Service No
indicates the service number.

Service Name indicates the name of the service.

Direction
, available with
Dual Test Set
or
Dual Port
topology,
indicates respectively results for local ( L ) and remote ( R ) directions, or
port to port directions.

CBS Test Time (s) indicates the total time required to perform all burst
sequence iterations of the CBS test for this service.

EBS Test Time (s) indicates the total time required to perform all burst
sequence iterations of the EBS test for this service.

Total Burst Test Time (s) indicates the total time required to perform
all burst sequence iterations of both
CBS
and
EBS
tests for this service.