EXFO MAX-800 Series, User Manual

Page: 365 / 495

Test Functions
MaxTester
357
Ping & Trace Route
Ping & Trace Route
From the
Test
menu, tap
Functions
, and the
Ping & Trace Route
tab.
Note:
For Dual Port topology select the port to be displayed.
Source IP Address
Displays or allows the selection of either the interface source IP address or
a stream IP address depending on the test and its configuration. Refer to
IP
on page 134, MAC/IP/UDP on page 121, or Smart Loopback on page 181.
Destination IP Address
Enter the Destination IP Address of the network device to be detected.
The destination IP address is configurable only with
IPv4 Network Layer
(refer to Modify Structure Button on page 65). The accepted range for IPv4
is
0.0.0.0
(default) to
255.255.255.255
.
The default setting for IPv6 is 2001:0000:0000:0000:0000:0000:0000:0000
or is set automatically to the IP address of the target unit from the Remote
Loopback mode. The destination IP address is configured only when
Ethernet/IPv6/UDP
is selected. The
IPv6 Address
can either be the
Link-Local IPv6 Address or the Global IPv6 Address . The acceptable
range for IPv6 is from
000:0000:0000:0000:0000:0000:0000:0001
to
FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF .
Stream
Stream is available with EtherSAM and Traffic Gen & Mon and allows
selecting a stream/service to use its source and destination IP addresses
for the Ping and Trace Route tests.