EXFO MAX-800 Series, User Manual

Page: 124 / 495

Test Setup - Test Configurator, Timer, and System
116
MAX-800 Series
Interface
Physical Interface
For parallel interfaces, the following information is displayed for each
optical lane.

Optical Lane indicates the optical lane number.

Laser indicates the status of the laser: ON with the laser pictogram
(emitting an optical laser signal) or
OFF
.

TX Power (dBm) indicates, when supported, the transmit power level
of the optical lane/laser in dBm.

Wavelength (nm) indicates, when supported, the detected
wavelength.

RX Power (dBm) indicates, when supported, the current received
power level of the optical laser/lane in dBm.
Green: Power level in range.
Yellow: Power level out-of-range.
Red: Loss of signal or power level is close to damage.
Gray: Invalid operational range value or not available/supplied by the
transceiver.
For parallel interfaces, in the
Test Configurator
-
Interface
block,
LO
and HI report respectively the current lowest and highest RX power
levels from any lane.

Min RX Power (dBm) indicates, when supported, the minimum
received power level of the optical laser/lane in dBm.

Max RX Power (dBm) indicates, when supported, the maximum
received power level of the optical laser/lane in dBm.
Optical Interface Optical Lane Number
100GE (4 Lanes) [103.125 Gbit/s] 0 through 3