EXFO MAX-800 Series, User Manual

Page: 142 / 495

Test Setup - Test Configurator, Timer, and System
134
MAX-800 Series
Network
Network
From the test menu tap
Setup
,
Test Configurator
, the interface block, and
the Network tab.
Note:
For Through Mode test application, the Network tab is only available for the
Primary Port but the configured parameters apply to both ports.
MAC

MAC Address indicates and allows changing, when the Factory
Default
check box is cleared, the default and unique Media Access
Control (MAC) address given to the Ethernet port.

Factory Default
check box, when selected (default), indicates that the
factory source MAC address is used.

Frame Format
(layer 2) allows selecting
Ethernet II
(default) or
802.3
SNAP as the frame format.
IP
IP Version allows the selection of either IPv4 (default) or IPv6 .
For
IPv4
the following configuration parameters are available.

Automatic IP (DHCP) check box, when selected (cleared by default),
allows obtaining an IP address dynamically from a DHCP (Dynamic
Host Configuration Protocol) server.

IP Address
1
: Enter the IP address of the port. The default setting is
10.10.x.y, where x and y are respectively the two least significant bytes
of the port default MAC address.
1. Not configurable when the Automatic IP (DHCP) check box is selected.