EXFO MAX-800 Series, User Manual

Page: 107 / 495

Test Setup - Test Configurator, Timer, and System
MaxTester
99
EtherSAM - Global
EtherSAM - Global
From the
Test
menu, tap
Setup
,
Test Configurator
, tap on the test block,
and on the Global tab.
Dual Test Set

Dual Test Set ( DTS ) check box when selected (cleared by default)
enables EtherSAM
Dual Test Set
. Once
Dual Test Set
is enabled, use
the Discover Remote button to select a remote unit. Not available in
Dual Port
topology.
Note: It is also possible using the Discover Remote button to connect to a remote
unit and automatically enable Dual Test Set. For more details, refer to
Discover Remote Button on page 380.

Disconnected
indicates that there is no connection established
with a remote unit .

NAT LAN/WAN
and
WAN IP
indicate presence of NAT (Network
Address Translation) router. The NAT router is automatically
detected and graphically displayed with LAN/WAN indication as
well as the WAN IP address when the
unit is behind a NAT router.
Note:
When there is a NAT at the Remote site, it is required to create UDP/TCP
port 62819 forwarding rule on this NAT router to allow DTS communication.
In addition, when there is a NAT in both directions (L->R and R->L), it is
also required to create port forwarding rules on the NAT router located at
the Remote side for every service defined.

Discover Remote button allows discovering remote unit supporting
Remote Loopback
and/or
Dual Test Set
. For more details, see
Discover Remote Button on page 380.