Endress+Hauser Analytik Jena multi EA 4000, Operating Manual

Page: 65 / 151

multi EA 4000 Commissioning
65
8. Repeat the process until the gripper is positioned just a
few millimeters below the boat storage. This prevents the
boat from moving when picked up by the gripper.
9. Click on [
SAVE AND EXIT
].
Sliding position
The sliding position is the cut-out in the sliding rod of the ce-
ramic hook. The sampler arm enters this cut-out and moves
the hook into the furnace.
1.
Place the ceramic hook and sliding rod against the stop
plate of the FPG 48.
2. In the window S
AMPLER
A
LIGNMENT
select S
LIDING POSITION
from the list and click on [A
DJUST
P
OSITION
].
The sampler arm moves above the sliding position.
3. Using the slider
HIGHER
/
LOWER
adjust the lowering depth
of the gripper. Using the buttons [L
EFT
]/[R
IGHT
] and [F
OR-
WARDS
]/[B
ACKWARDS
] adjust the position in the cut-out.
The gripper must be adjusted flush right and centered in
the cut-out. The gripper must hover approx. 1 mm above
the cut-out. The sampler arm must not exert any pressure
on the sliding rod.
4. Set the new position by clicking on [A
DJUST
P
OSITION
].
5. Repeat the process until the adjustment is correct. Finally
click on [
SAVE AND EXIT
].
Ejection rail
Only if the boat storage is fitted (e.g. when using the auto-
matic TIC solids module)
1.
In the window S
AMPLER
A
LIGNMENT
select E
JECTION RAIL
from
the list and click on [A
DJUST
P
OSITION
].
2. Using the slider H
IGHER
/ L
OWER
adjust the lowering depth
of the gripper.
The gripper must hover approx. 1 mm above the rail and
must not rest on it.
3. Place a boat next to the gripper and check that the boat
cannot slide under the gripper.
4. Set the new position by clicking on [A
DJUST
P
OSITION
].
5. Once the position has been adjusted click on [S
AVE AND
EXIT
].