CPX230NWB ALARM CONTROL PANEL – INSTALLER MANUAL
61 / 144
EN
NOTE: Remote configuration via CSD channel is available only in case
the CSD data transfer is active for both SIM card inserted in the
equipment and SIM card installed in GSM modem. Additionally, the
control panel must accept CSD connections – see item 6.7.1.2.
Authorized GSM Modems Numbers.
Programming through CSD connection is possible also when OSM.Server system is
installed, with at least one GSM modem connected. If the device is registered for the
server (serial number and SIM card number – see OSM.Server Manual) you can use the
connection via OSM. Provided that no GPRS connection is established. Programming
attempt (via GPRS connection – see the above) will end with a question whether you
want to use a modem connected to the server. If the answer is yes, the procedure will
continue as in case of other programming channels.
5.3.1.6.
File -> Automatic device settings backup
All configuration wizard’s settings, both these read from devices and these saved in the
equipment are automatically recorded on a hard drive. If, during configuration wizard’s
installation no directories were changed, the files can be found in e.g.:
C:\Program Files\EBS\KonfiguratorLX\configs\CPX230NWB_20000\
CPX230NWB_20000 directory contains all files related to programming the CPX230NWB
type device of the serial number 20000. Files names contain date and time of the
operation and its type (recording/reading). The files are recorded with .cmi extension.
5.3.1.7.
File -> Exit
Ends the program operation.
5.3.2.
Menu -> Operations
5.3.2.1.
Operations -> Read
The function reads the data saved in the memory of GPRS module. Data is exchanged
through the port selected in the section “Select connection type” (see the description of
“Configuration” option below). A correct readout is confirmed with relevant message. You
can save the data downloaded from the equipment in a file (see item 5.3.1.3.), and then
use it for other devices.
You can use that function after you define a type and parameters of the connection. E.g.
for local connection the following window is displayed:
