CPX230NWB ALARM CONTROL PANEL – INSTALLER MANUAL
45 / 144
EN
4.3.17.
Remote controllers configuration
4.3.17.1.
Remote controllers configuration
Remote controllers can be configured using complex service functions, after activation of
which, all the parameters related to the relevant remote control can be given subsequently
or in a form of series of service functions that configure one remote control related
parameter. Codes of the remote control configuration functions are defined as per the
following pattern:
<XX> <Y>
<Z>
Where:
XX
– determines the number of remote control for
01
to
32
,
the table below shows
remote control names and their corresponding numbers:
Name A1 A2 A3 A4 A5 A6 A7 A8 B1 B2 B3 B4 B5 B6 B7 B8 C1 C2 C3 C4 C5 C6 C7 C8 D1 D2 D3 D4 D5 D6 D7 D8
Number 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32
Y
– number of parameter related to a given remote control
Z
- number (or value) of the next parameter;
For Y=0
– complex function, the initiation of which configures the parameters listed
below as set of parameters.
For Y=1
– Delete a remote control. After selecting this option, you can confirm deleting
by pressing
key, or you can cancel function by pressing
key; no
Z
parameter.
For Y=2
– Add a remote control. After selecting this option, any key on the remote
control has to be pressed. Once the transmission with the remote control is
established serial number will be displayed on the keypad (hexadecimal value). If
accepted, the remote control will be saved; no
Z
parameter.
For Y=3
– type of the remote control (read only); no
Z
parameter.
0 – no remote control
2 – RC-10 remote control
For Y=4
– The user to which the remote control is assigned
For Y=5, 6, 7, 8
– Functions for the remote's buttons, where 5 means button , 6 –
, 7 –
, 8 –
; possible values for
Z
:
0 – no function
1 – arm (fully armed)
2 – disarm
3 – alarm
4 – silent alarm
5 – enable output 1
6 – enable output 2
7 – enable output 3
8 – disable output 1