CPX230NWB ALARM CONTROL PANEL – INSTALLER MANUAL
93 / 144
EN
6.6.1.1.
GPRS ON/OFF
In these columns you can check which signals are to be reported to the monitoring
station via GPRS transmission. You have the option to send information on both, alarms
(change of zone state from idle into active) and returns of zones states from active into
idle (normalisation). In order to transmit a particular signal you have to check it (by
clicking a relevant check box on the right hand side).
Press [Clear] button to remove all checked signals.
Press [Reverse] to reverse the check into the opposite ones.
6.6.1.2.
SMS ON/OFF
In these columns you can check which signals are to be reported to the monitoring
station via SMS message – when the equipment is not connected with server via GPRS
connection. You have the option to send information on both, alarms (change of input
state from idle into active) and returns of zone states from active into idle (normalisation).
In order to transmit a particular signal you have to check it (by clicking a relevant check
box on the right hand side).
Press [Clear] button to remove all checked signals.
Press [Reverse] to reverse the check into the opposite ones.
6.6.1.3.
Power loss
One of the additional options of the equipment is the control of supplying voltage. As
transient power losses can occur in some facilities, you can avoid reporting them by
entering the time after which the information will be sent. The value of the parameter
means that power loss must last for that pre-defined time for the equipment to recognize
it a factual power loss and to send a relevant message.
6.6.2.
Additional data
The Additional data functionality allows for defining kinds of additional data which will be
transmitted together with events to monitoring station via GPRS/SMS. The data may
become valuable information about device's work conditions though it may increase
amount of bytes sent through GSM network.
