![background image](http://html1.mh-extra.com/html/ducati/monster-695/monster-695_user-manual_2537677621.webp)
Immobilizer and Transponder
4 Release the throttle when the EOBD light goes off.
5 Repeat operations described in steps 3 and 4 until you enter the last digit.
6
After releasing the throttle twistgrip and if the entered code is correct, the EOBD light will flash for
4 seconds to indicate that the immobilizer is now disabled. Then it turns off. It will immediately turn
off if the engine is started before 4 seconds have elapsed.
7 If the code is NOT correct, the EOBD light stays on. Repeat the procedure from step 1. There is no
limit, the procedure can be repeated as many times as needed.
Note
Each time the key is positioned to OFF after overriding the immobilizer as described above, upon the
following key-ON the same error will show (and engine is disabled again). The above procedure should
be repeated to override the immobilizer system again and enable engine starting.
The electronic code can be entered even via "DDS" as described in
“
Removing the immobilizer
Turn the ignition switch to
OFF
.
Disconnect the immobilizer antenna connector (5) at the bottom end of the switch assembly.
Disconnect the switch connector (4).
Note
References (4) and (5) are the same as those of diagrams under
Arrangement of wiring on frame
”
of
Sect. P 1.
file:///C|/Documents%20and%20Settings/F4i/My%...manual/wsm/usa/Mon695_MY07_P_8_9_00.85.1.html (6 of 9) [10/7/2008 8:47:22 PM]